BumbleBee, Rocket Building, Testing

Trial Carbon Fibre Layup

Did a trial run doing a layup of Carbon Fibre on to G10 material on the weekend.

Layup consisted of:-
* Small piece of G10 material “roughed up” with Grit 60 sand paper,
* Two layers of CF
* Two pieces of Nylon Peel Ply
* K3600 Renlam Epoxy

The first piece of carbon fibre extended past the edge of G10 by about 15mm. The second layer was 5 mm within the edges.
I waited 5.5 hours after the layup to cut the excess off CF. It was easy to do.
Waited another 15 hours before I removed the Peel Ply. It was easy to remove the Peel Ply.

Below are some photos I took.

Weighing the G10 material
Weighing the G10 material

 

 

Weighing one piece of CF
Weighing one piece of CF

So therefore the large piece of carbon fiber weights ~3 grams.

 

Weighing two pieces of CF
Weighing two pieces of CF

So therefore the smaller piece of carbon fiber weights ~2 grams.

 

Mixed up the Renlam Epoxy.
Mixed up the Renlam Epoxy.

 

Applied a generous amount of Epoxy to the G10 plate.
Applied a generous amount of Epoxy to the G10 plate.
Placed Carbon Fibre on to the wetted G10 plate.
Placed Carbon Fibre on to the wetted G10 plate.

 

Applying more epoxy to first layer of Carbon Fibre - don't want to miss any bit of it.... and Added second piece of Carbon Fibre
Applying more epoxy to first layer of Carbon Fibre – don’t want to miss any bit of it…. and Added second piece of Carbon Fibre

 

Wetted out the second layer of Carbon Fibre.
Wetted out the second layer of Carbon Fibre.

 

Applied two layers of Nylon Peel Ply
Applied two layers of Nylon Peel Ply
Nylon Peel Ply completely wetted out.
Nylon Peel Ply completely wetted out.
Added Magnetic sand (in two bags) on to the job. Then placed wood and 4kg weight on top.
Added Magnetic sand (in two bags) on to the job. Then placed wood and 4kg weight on top.

 

5.5 hrs has passed and about to trim off excess material.
5.5 hrs has passed and about to trim off excess material.
Trimmed excess quite easily/quickly with a pair of scissors.
Trimmed excess quite easily/quickly with a pair of scissors.
IMG_6014
Used a sharp knife to initiate removal of Peel Ply ~24hrs after starting Lay up.
Completely finished Lay up! (except for the finish itself)
Completely finished Lay up! (except for the finish itself)

Final Weight: 44 grams

This means the Epoxy weight was approximately:  2 grams

So the total weight of the epoxy/CF is 3 + 2 + 2 = 7 grams. Very light!

The carbon fibre seems to have bonded well with the G10 material. The resultant piece is a lot stiffer.

My next step (if this was the real fin) would be to apply a very thing coat of K3600 and then sand with progressively higher grits.

Now considering a real fin layup this weekend.